Recent content by Bill Trainer

Thanks guys, the beads are loose.. just trying to get them to pull over the wheel rim. Will take my time. Happy holidays

Thanks Tim, uhm, what is a "death wheel"?

resurrecting this thread.. I am trying to remove some brick hard Goodyear 430 10" cantilever slicks off some 7" wheels - they must be 15 years old and are sun dried. I have the beads off and slit the circumference, actually removed 4" of the tread center but can't get the bead to move over the...

Has anyone used the MAP sensor option to enhance timing advance? How does it work? Thanks

If an aluminum wheel gets scored on the inside turn going up to the bead, can the scoring be welded or repaired? or is it scrap? thought I would see before tossing it. Thanks

Hi, I run an H-Prod VW MK2 Scirocco with a welded diff and have developed a chronic drivers side outer cv joint breakage issue. I am now losing one every event - any suggestions on how to fix it? Thanks

http://scca.cdn.racersites.com/prod/ass ... .29.12.pdf

Hi, Does anyone know where I can find 12" and 6" braided steel brake lines with female 10 x 1.0mm ends? seems all I can find is AN ends. thanks

What is the best way to clean the intake and exhaust carbon build up in the head chambers? I am reluctant to use wire brushes because I do not want to give the appearance of "machining" - its LP. I have been using nylon brushes and steel hand brushes with carb cleaner or mineral spirits based...